Preparation and operating procedure

ATTENTION! Before inclusion of the device after stay it at temperature lower 5C to sustain it at room temperature not less than 2 hours.

1. To inspect the device. To establish a regulator of a voltage in a zero situation. If necessary to carry out disinfection of electrodes.
2. To connect the power supply — either battery, or network transitive device.
3. To impose electrodes on the chosen sites of a body, previously having removed from them protective plates. The places of imposing of electrodes on a body should be dry and previously are cleared of a dirty and fat by spirit or clean water.
4. To connect electrodes to the device (top jack).
5. To include the device by a regulator of the voltage. At the moment of click three indicators can quickly light up. Choose a mode of influence by pressing of a key on the forward panel. The absence of a luminescence of indicators testifies about spacing of batteries or malfunction of the device.
6. By a regulator of the voltage to choose force of influence. At first, it is necessary to establish weak force of influence, after adaptation to which, it can slowly be increased.
7. If necessary changes of a mode of influence, at first it is necessary to set by a regulator of the voltage in a zero situation, and then to press a key of a necessary mode of influence.
8. After the ending of stimulation to switch off the device, having set a regulator of the voltage in a zero situation before click. Then to remove electrodes from the patient and to protect them by their plates. IT IS IMPOSSIBLE to connect electrodes among themselves at the included feed of the device.
9. It is not recommended to leave the battery in a compartment of a feed long time in order to prevent damage of the device because of possible outflow of electrolyte from the battery of a feed.

To keep the device follows in a dry and cool place. At loss of stickiness of electrodes, it is necessary slightly to moisten them by water.

ATTENTION! It is impossible plentifully to water electrodes and to influence by water more than 30 seconds. Electrodes-plates are replaced in process of their wear process. One plate suffices a minimum on 200 times of use.